Upgrade your guitar's tone with our Pre-Wired Stratocaster pickguards. Crafted with top - notch components in the same factory as our famous guitars, this drop - in pickguard is a breeze to install. Just take out the old guard, solder the output jack and ground wires, screw in the new one, and you'll be playing with that pure Fender sound right away. These pickups have a bit more output than typical vintage ones, and with a powerful magnet combination, they create a perfect balance of clean, dirty rhythm, and lead tones for players of all skill levels, no matter what amplifier you use. The neck pickup is inspired by a '54 Strat pickup with big alnico 3 magnets. The middle pickup, based on a '63 Strat, uses specially treated alnico magnets and is reverse - wound to stop humming when paired with the neck or bridge pickup. The bridge pickup has alnico 5 magnets and is tuned for more output without losing that lovely top - end sparkle. Features include a hotter output bridge pickup, highly dynamic and balanced output, oversize alnico 3 magnets in the neck pickup, alnico 5 magnets in the bridge and middle pickups, and a reverse - wound middle pickup to get rid of hum. Specifications: Bridge - Custom Eric Johnson Signature Stratocaster® Bridge Pickup; Middle - Custom Eric Johnson Signature Stratocaster® RWRP Middle Pickup; Neck - Custom Eric Johnson Signature Stratocaster® Neck Pickup; Style - 3 Single - Coil; Configurations - SSS; Magnet Type - Neck and Middle: Alnico 3, Bridge: Alnico 5; Magnet Wire - Formvar - coated; DC Resistance - 6.7 - 6.9k (Bridge), 6.3 - 6.5k (Middle), 5.8 - 6k (Neck); Inductance - 2.9 - 3.1 Henrie (Bridge), 2.5 - 2.7 Henries (Middle/Neck); Bobbin Material - Fiber; Lead Wire - Cloth - covered; Pole Pieces - Staggered; Tone - Vintage; Output - Vintage; Switch Tip - Aged White; Controls - Master Volume, Tone 1. (Neck Pickup), Tone 2. (Bridge Pickup); Pickguard - Stratocaster®; Ply - 3 - ply Mint Green; Control Knobs - Aged White; Hardware Finish - Chrome.
Using this Fender Eric Johnson Pre - Wired Stratocaster Pickguard is easy. First, remove the old pickguard from your guitar. Then, carefully solder the output jack and ground wires. After that, just screw in the new 3 - ply mint green pickguard. You're all set to start playing with great Fender sound. When it comes to maintenance, keep your guitar in a stable environment, away from extreme heat or cold. Avoid getting the pickguard wet, as this could damage the components. If you notice any loose wires or parts, it's best to have a professional guitar technician check it out. And remember, don't use abrasive cleaners on the pickguard or hardware, as this can scratch the finish. With proper care, your pickguard will keep sounding great for a long time.
