The AT-VM95E from the VM95 Series is a top - notch dual magnet cartridge. It comes with a 0.3 x 0.7 mil elliptical stylus, perfect for half - inch mount turntables. Thanks to its special coil design, it pumps out a powerful 4.0 mV output level. You'll enjoy excellent channel separation and low distortion, resulting in amazing tonal quality. The durable, low - resonance polymer housing has threaded inserts. This means you can easily mount the cartridge to the headshell with just two screws, no nuts needed. And since all VM95 Series cartridges have the same body, you can swap the stylus with any of the six AT - VMN95 replacement styli. Features include an aluminium cantilever, specially wound coils for increased output voltage, and a design compatible with AT - VMN95 replacement styli. Specifications cover frequency response from 20 - 22,000 Hz, 20 dB channel separation at 1 kHz, and more.
Using the Audio - Technica AT - VM95E is a breeze. First, make sure your turntable has a half - inch mount. You can easily install the cartridge on the headshell using the provided two 11 mm or two 8 mm installation screws and washers. Just align it properly and tighten the screws. When playing records, set the vertical tracking force between 1.8 - 2.2 g, with 2.0 g being the standard. As for maintenance, keep the stylus clean. You can use a stylus brush to gently remove dust after each use. Also, avoid touching the stylus with your fingers as the oils can damage it. If the sound quality starts to degrade, you can replace the stylus with an AT - VMN95E replacement stylus. Store the cartridge in a dry and clean place when not in use to prevent any damage.
